<strong>OE Number</strong><ul><li>34356891421/34-35-6-891-421/34131093/341-31093</li></ul><strong>Fitment</strong><ul> <li>For B-MW F48 Series X1 2023-2025</li> <li>For B-MW F39 Series X2 2024-2025</li> </ul><strong>Specification</strong><ul> <li>Total Length: 69.4cm/27.3inch</li> <li>Installation Location: Rear Left and Right</li> <li>Pins: 2</li> <li>Material: Metal, ABS</li> <li>Package: 2x Brake Pad Wear Sensor (2 Pins)</li> <li>This is a non-OEM product, accessory only!</li> </ul><strong>Features of Brake Pad Wear Sensor</strong><ul> <li>1. Wear Detection: Monitors brake pad thickness and reminds when replacement is needed.</li> <li>2. Timely Warning: Triggers dashboard indicator before pads wear to unstable levels.</li> <li>3. Contact Sensing: Metal contact wire breaks when pad wears down, sending signal.</li> <li>4. Safety Assurance: Prevents metal-on-metal braking and rotor damage.</li> <li>5. Durable Housing: ABS plastic shell resists heat, moisture, and road debris.</li> <li>6. Metal Conductive Tip: Embedded metal wire ensures accurate wear detection.</li> </ul><strong>Effects of Failed Brake Pad Sensor</strong><ul> <li>1. No Wear Remind: Damaged sensor fails to notify driver of worn brake pads.</li> <li>2. Rotor Damage: Unchecked pad wear causes metal-on-metal scoring of rotors.</li> <li>3. Braking Failure: Severely worn pads lead to reduced or complete brake failure.</li> <li>4. Safety Hazard: Unknown pad wear compromises stopping power and road safety.</li> </ul><strong>Installation of Brake Wear Sensor</strong><ul> <li>1. Prepare: Lift vehicle, remove wheel, and locate old wear sensor on brake pad.</li> <li>2. Remove Old Sensor: Disconnect electrical connector and pull sensor from pad clip.</li> <li>3. Install New Sensor: Insert new sensor into pad, route wire, and connect plug.</li> <li>4. Verify: Reset dashboard warning, test brakes, and ensure no error codes appear.</li> </ul>