La Pavoni Europiccola Chrome Base Pin Bottom Style (2019 and onwards models) Pavoni sku 2241001041 NOTE: The finish inside is never as “pretty” and clean looking as the outside. Fits: All Europiccola and Professionale around and after 2019-2020 when La Pavoni changed to the "3-hole" version that locks the boiler in place on the base. (Note that you must also have the 2019 and later boiler with the 3 corresponding pins to use this newer style base. For the PRE 3-Hole style base see here. In 2008 the base was redesigned. The dimensions are still the same, however, the screw is now accessed from the bottom, which will help keep water and coffee from leaking onto the components within the base and causing issues with rust. When replacing the Chrome base, the ABS under base and the screw need to be replaced as well. Logo sold separately. NOTES: To remove the old base, you’ll need to remove the Heating Element, and you should replace the gasket when reinstalling it - either the P-7ss (for stainless steel elements) or the P-7 (for the older-style brass and copper elements). If the spacers above and below your current base are no longer in good shape, they’ll need to be replaced as well (each machines uses two). P-4E is for the smaller 8-cup boiler, and P-4P is for the larger 16-cup boiler. Depending on the age of your machine, you may need to add the power cord grommet, P-84. Some Pavoni base screws have a Torx head, which came in two different sizes. Please see “you might need” parts below.